When LESS is MORE
Techniques for Flat Turns, to conserve altitude...
The first in a 4-part series on WS by Matt Gerdes and Taya Weiss, things you should know about your first flight course. If you already took your FFC you can use this article to see if you missed something. If you're planning to take one in the future then you'll know what your instructor should cover…
(A summary of everything you should learn during your First Flight Course.)
“200 skydives” – It sounds like a lot, when you don’t yet have them. But 200 skydives is not many, and in some cases it’s not enough to prepare people for the added complexity of flying a wingsuit, which reduces safety and comfort in almost every area of skydiving from exiting the plane to deploying your parachute…
If you can, wait longer than jump 201
For many people, this number is a formidable barrier to entry and if wingsuit flying is your goal, it can be tempting to begin immediately at jump number 201. If you can, wait longer. The more skydives and tunnel time you log, the more you will learn to fly your body in different orientations, experience and recover from instability in freefall, and become familiar with your gear. All of these things will give you a faster learning curve in a wingsuit and will make you a better overall pilot as you progress.
Regardless of when you begin wingsuit flying, or when you began it, here are the things that should be covered in every FFC (First Flight Course). We’re not going to delve into the details of every topic, as that’s more of a book than an article, but we do want to highlight some critical items that every new wingsuit pilot should understand and experience before beginning their solo progression.
In subsequent articles, we will cover best practices for everything from exiting the plane to breaking off. This first instalment is a sort of checklist for your first wingsuit jumps with an instructor.
Wingsuit flying requires that you adapt your equipment to the practice. While some rigs are not “freefly friendly”, most rigs - even modern ones - are not “wingsuit friendly”. Make sure that your equipment is fully appropriate for your first wingsuit jump before your FFC.
Automatic Activation Devices are an important safety tool for wingsuit skydiving. There is no downside to having one when flying a wingsuit. There have been cases where an AAD did not fire during out of control flight due to slow descent rate or varying pressure areas. However, there have been several documented saves and AADs should be considered mandatory
An 8 to 9-foot bridle (measured from pin to pilot chute) extends the pilot chute further from the wingsuit wake turbulence. Bridles shorter than 7 feet increase risk of the pilot chute being affected by wake turbulence and leading to a PC-in-tow.
OPEN CORNERS MODIFICATION
Any master rigger can modify a container to “open the corners” at the bottom of the main pack tray. The bottom flap of the main tray opens completely (lying flat when open on the floor) reducing the likelihood of the deployment bag snagging on a corner during a more horizontal extraction (due to the forward movement of the wingsuit skydiver).
Your FFC instructor should explain the processes by which a wingsuit inflates and generates lift. They should define: Pitch; Angle of Attack (“AoA”); Airspeed vs Groundspeed; Anhedral vs Dihedral; Body Configuration vs Body Position, and how these differ and are independent from Pitch and AoA.
The suit you use for your first jumps should be deemed by the manufacturer to be suitable for FFC use.
When you learn to attach your suit to your harness-container system, use a system that is clear and repeatable to build good habits. Always verify before gearing up: Handles, Chest Strap, Leg Straps:
Learning to Gear Up and Prepare
Wingsuits require a little extra time to prepare - manifest accordingly. You’ll need to gear up on the 20 minute call to allow time for practice touches and review in full gear.
Gear up in order of skydiving priorities: RIG FIRST, then wingsuit.
Your coach should complete a full gear check, including verifying that your audible altimeter is set to correct altitudes.
Creep it out. On the creeper, your coach should cover various body configurations, adjustments to AoA and heading, practice touches with smooth transitions back to flight, wave off, and mock deployments.
Starting at the mockup, your coach should cover:
Prior to boarding, another gear check should be completed. Your leg wing should be on and fully zipped before boarding the plane. After takeoff, review the jump plan step by step, and communicate with the pilot about aircraft settings for a wingsuit exit.
Prior to exit, a final gear check should be completed. Ensure that you touch handles and visualize emergency procedures. Check that cutaway and reserve handles are fully available and securely in place, before moving to the door of the aircraft.
Your first jump will start with a careful spot, by you: remember that wingsuits rarely exit directly over the DZ. You must have a clear visual on the DZ. Confirm to the coach that you see it.
In the following installment, we’ll cover good exit technique and other wingsuit flight topics in greater detail, and for pilots of all levels. For now, here are the points that should be covered during your first few jumps during your FFC:
We recommend doing two early in your first jump, preferably performed on jump run before any other maneuvers. If long spot, one or more can be performed after one 90-degree turn.
Your first jump will involve a simple pattern of flight, bringing you back to the appropriate place to open your parachute near the DZ. Turns should be flat, controlled, and limited to 90 degrees at a time.
Break-off should occur higher on your first few jumps - your alarms are set to start at 6,500 ft and this is a good altitude to check your location and adjust as necessary to arrive at the deployment zone for your flight pattern. As with any skydive, we wave off before deployment in a wingsuit. Some coaches teach leg kicks, but we’ve seen this become an excellent source of control-loss for newer pilots, with little added benefit on a 2-way. Wave off with hands only to begin with.
Wave off with hands only to begin with
The basics for a beginner wingsuit deployment involve a controlled arch, symmetrical pull with both hands/arms (as if there were two pilot chutes), gently bent knees for easier BOC access, and actively continuing to fly your body and your opening parachute throughout the deployment process. Refer to Wingsuit Deployments for more on this subject, or visit https://nextlevel.ws/knowledge-base to read more articles on this complex segment of the skydive.
The objectives for your first few flights are to learn to exit safely, navigate with control and precision, deploy your parachute correctly, and land on the DZ. During these coached jumps and the subsequent de-briefs, your instructor should cover techniques for an efficient but relaxed and “neutral” flight at a responsible AoA (not near-stall). You should become comfortable with spotting your exit (it will be longer than you’re used to) and flying a pattern that does not interfere with any other groups. You should be able to gauge airspeed and aircraft settings on jump run to determine if it’s safe to exit, complete several different types of exits, and be briefed on floating (front and rear), backfly exits, and exiting both poised and running from inside the plane.
During flight, your instructor should work with you to make vertical and horizontal adjustments relative to a base in a formation, as well as speed and angle changes to approach and decelerate with control, relative to the base. You should finish the FFC with a basic understanding of energy management and how to achieve and control changes in airspeed.
Hopefully, your coach is hooked up with The Sigma, and the final step will be a First Flight Course Merit which is an asset if you visit other DZs. Either way, make sure to get your logbook signed off with a description of what you achieved and whether you are cleared for solo supervision. At the conclusion of your FFC, you should have demonstrated the basic skills listed above, as well as shown the ability to self-supervise as you improve upon the basics. And hopefully you’re hooked!
In the following three weekly instalments, we’ll cover the various parts of a wingsuit skydive in more detail, and for pilots of all abilities…
This article is one of a 4-part series by Matt Gerdes and Taya Weiss on Wingsuit Progression. Here are links to the other articles:
Part 1 – First Flight Course - this article - here
Part 2 – WS Exits from the Plane - next article - here
Part 3 – A Wingsuit Skydive from Start to Finish - here
Part 4 – Making it Back (alive and well) - here